Top 10 common forklift mishaps ， forklift operation should take note of these matters ！.

Top 10 common forklift mishaps ， forklift operation should take note of these matters ！.

Blog Article

Do not undervalue the forklift at the workplace. If the procedure is not good, there will certainly be serious accidents in minutes, and there are several crashes involving forklifts.

Case 1: The forklift freight obstructed the motorist's view, and the person ahead can not be discovered, resulting in a moving mishap.
Case 2: In order to keep the balance of the forklift when lifting hefty products, the employees utilized their body weight as the counterweight, which almost created casualties.
Situation 3: The size of the forklift cargo surpasses the allowed size of the route and holds on the roadside rack, which virtually triggers an crash.
Situation 4: Forklift is speeding and surrender during a turn.
Case 5: The forklift motorist did not see the pedestrian, and the pedestrian did not discover the forklift.
Case 6: The forklift raises the workers illegally, the forklift vehicle driver does not put on the seat belt, the forklift lifter drops and the vehicle driver is squashed when the forklift rolls over.
Instance 7: The forklift motorist did not wear a safety belt and dropped from the car when it rolled over and was squashed.
Forklift procedure must pay attention to these matters ：.

Begin.
1. Before starting, observe the surroundings, and after confirming that there are no challenges that impede the safety and security of driving, honk the horn first and after that start.
2. For vehicles with hydraulic (air pressure) brakes, the brake hydraulic pressure (air pressure) scale have to be safe prior to beginning.
3. When the forklift begins with a tons, the vehicle driver needs to initially verify that the tons is secure and reputable.
4. The begin has to be slow and constant.

Driving.
1. When driving, the elevation in between the bottom end of the fork and the ground ought to be maintained 300mm-400mm, and the mast needs to be tilted backwards. .
2. Do not raise the fork too expensive when driving. When entering and leaving the job website or while driving, be careful that there will certainly be no obstacles in the sky. When the lots is traveling, the fork has to not be raised expensive, which will certainly influence the stability of the forklift. .
3. After discharging, the fork needs to be reduced to the normal driving setting before driving. .
4. When transforming, if there are pedestrians or lorries close by, the driving signal must be released initially. High-speed sharp turns are banned. High-speed sharp turns will trigger the automobile to shed lateral security and tip over. .
5. When the forklift is downhill, it is purely restricted to turn off the fire and slide, and it is restricted to brake suddenly while driving with tons unless there are unique situations.
6. When the forklift is running, it has to follow the website traffic rules in the factory and need to maintain a specific safety range from the automobile ahead. .
7. When the forklift is running, the lots needs to be in the most affordable placement that does not hinder the driving, and the gantry needs to be properly slanted back. The load will not be increased other than when piling or filling. .
8. The elevation of the load should not block the vehicle driver's sight. In unique circumstances, when the product affects the forward vision, drive at a reduced rate when turning around.
9. It is restricted to activate the ramp, neither to drive throughout the ramp. .
10. The safe driving speed of the forklift in the factory location is 5 km/h, and it has to drive safely at a low rate when entering the manufacturing workshop area. .
11. When the forklift is lifted, lifted or driven, it is restricted for employees to stand on the fork to hold things and play a balancing role. .
12. If issues are located, they will be repaired and reported in a prompt fashion, and they will certainly never run with diseases or hide them.

packing and dumping.
1. When fork-loading things, the range in between the two forks should be changed as needed to make the load of both forks well balanced and not skewed, and one side of the item should protest the rack. .
2. It is forbidden to collaborate with a single fork or utilize a fork top or pull. In unique situations, security indication need to be established to remind bordering pedestrians. .
3. In the process of packing and discharging items, the forklift must be stopped with the brake. .
4. The rate of the automobile should be slow-moving and consistent. Take care not to roll the wheels on the dunnage, so as not to extend the rolled items and injure individuals. .
5. When using a fork to fork the goods, the fork needs to be as deep as possible under the lots, and it ought to be kept in mind that the fork tip ought to not touch various other items or things. The load should be supported with minimal back tilt of the gantry so that the load does not move backwards. The mast can be tilted onward somewhat when the load is reduced to permit easy positioning of the load and extraction of the forks. .
6. It is restricted to fork items at broadband and hit difficult items with the fork head. .
7. When the forklift is working, it is restricted for people to stand around the fork, so as to prevent the collapse of the goods and harm people. .
8. Overloading is forbidden, and it is forbidden to utilize forks to lift personnel to engage in high-altitude procedures to stay clear of high-altitude falling mishaps. .
9. It is not enabled to make use of the brake inertia to slip, put, round or roll items. .
10. It is not enabled to make use of forks to pick, transform pallet dump.

Leaving .
1. It is restricted to leave the forklift when the items on the fork are in the air. Before leaving the forklift, you should dump the goods or reduced the fork structure.
2. Draw the emergency brake manage to dead or dispirit the emergency brake switch.
3. The engine is shut off and the power is removed. (Except for unique situations, such as the motorist does not leave the vehicle's line of vision and does not surpass 1 minute).
4. Eliminate the secret. .

Forklift Operation Precautions.
1. Prior to and after the forklift procedure, the appearance should be inspected, and fuel, lubricating oil and air conditioning water ought to be added.
2. Inspect the safety performance of starting, running and braking.
3. Check whether the lights Electric Forklift Truck for Warehouse and horn signals are complete and reliable.
4. During the operation of the forklift, inspect whether the stress and temperature level are normal.
5. After the forklift is running, the exterior leak should likewise be examined and the seals must be replaced in time.

Forklift Safety Operation Specifications.
1. You must examine before leaving the vehicle;.
2. When you experience someone before you during driving, you must send a signal at a distance of 5 m;.
3. The driving rate in the factory does not go beyond 5 km/h;.
4. When driving, the nadir of the cargo ought to be 0.3 m ~ 0.4 m above the ground;.
5. The turning need to not be too sharp to prevent the propensity of "free turning";.
6. Adding and down the incline must be sluggish and consistent, and no activating the slope is allowed.
7. Do not drive throughout the slope. When the slope is more than 10%, the car should be driven in reverse when worsening;.
8. When the forklift employees carry the goods and progress, if they come across big or hefty goods and go to the chauffeur's line of vision, they should take the reversing workout
.
The "Eight Prohibitions" need to be adhered to in the procedure.
1. Solitary fork operation is not enabled.
2. It is not allowed to lift the goods for long distance Stand-on Electric Pallet Stacker driving.
3. It is not enabled to pick up the goods by turning over the pallet with the fork.
4. It is not enabled to directly shovel chemicals, flammables and other hazardous chemicals with forks.
5. It is not enabled to utilize inertia pressure to get the goods.
6. It is not permitted to use stopping pressure to expatriation round or easy-to-roll items.
7. It is not allowed to bring people to work with the pallet or fork, and it is strictly forbidden to stand under the fork after the fork is raised.
8. Do not drive laterally on slopes
.
Vehicle parking is not allowed under the following problems.
1. Curves, narrow roads, railway crossings;.
2. Sections with a longitudinal slope above 5%.
3. When there is an barrier on one side of the road, the contrary side of the area with the very same size as the challenge need to be within 20 meters at each end.

Web：https://www.onenforklifts.com/
Email：info2@onen.cn
Phone：+86 13827083844